![]() He's taking the output from his polling code and then using that to create the web page - so you'd have to whip up something to do that as well.Īs for historical logging and/or graphing - where do you keep the logs?. His code depends on libmodbus, and you'd need to get that compiled and installed on whatever your router OS is (dd-wrt?). Looks like he's running his on a computer, not a device so there are some issues I can see right off. ![]() I would double check it against the Duo MODBUS spec sheet just to check for diffs, since he wrote his for an MPPT. Seems like that that guy at the linked blog has the polling nailed with his C code. If MSView is distributed as a pre-compiled Windows binary, then it is what it is - running it under Linux will pretty much require either Wine or a VM setup. its still just a hobby for me but I tend to get carried away with it sometimes. Thats probably the best place to start but Im still just gathering info for a winter project if/when time permits. Member westy1982 has programmed his own version to read the MS MODBUS I was hoping to find a good starting point that I might could strip down small enough to be able to run on my router as a drone. the standard graphs are very hard to read since there is no grid background.Ībout the linux options, wine and Vmware are good suggestions but I should have been more clear. Ive mentioned it to their techs before the latest update but it wasnt adressed.Ī more user customizable historical graph would be great. battery voltage titles since they are reversed and max. The first thing I would do is correct the min. its just the basics though but thats better than nothing I guess. Im still getting familiar with it but so far it can tell it has a whole lot of room for improvement. ![]() Not many here make use of the MorningStar software it seems. Is anyone else here using the msview data logging with historical graph without issues on other MS Charge controllers or have any issues other with MSView software?Īlso has anyone been able to run msview in linux and if so what version? MS tech support says its not officially supported but has been reported to work but could not specify on exactly what flavor. ![]() charge regulation set point I still get a higher charge voltage and while trying to make use of the historical graph feature with a saved data log the program will frequently stop responding but then after I close and reopen the program and do the same drag-n-drop to the graph it will then work OK. Im not so sure msview is ready for prime time, at least in combination with the SSD charge controller.Īfter setting the max. I have been able to program custom set points with older versions of msview but the data logging is new feature. I have a morningstar SunSaver DUO charge controller and morningstar has recently released a version or msview (1.3.18.0) that has data logging for this controller. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |